12/14/2023 0 Comments Balboa spa control panel 51406![]() ![]() Most changes are not saved unless Light is pressed. Waiting a few seconds in the Main Menu will allow the display to revert to the Main Screen. Power-up ScreensĮach time the System powers up, a series of numbers is displayed.Īfter the startup sequence of numbers, the system will enter Priming Mode. Waiting time (depends on menu item) that reverts to original setting and ignores any change to that menu item. Waiting time that keeps the last change to a menu item. Light or dedicated "Choose" button, depending on control panel configuration Indicates Alternating or Progressive Message - every 1/2 second Simply waiting for a few seconds will return the panel operation to normal. The menus can be exited with certain button presses. Pressing the LIGHT button while the numbers are flashing will enter the menus. Typical use of the Temperature button(s) allows changing the Set Temperature while the numbers are flashing in the LCD. The LIGHT Button is also used to choose the various menus and navigate each section. Panels that have two Temperature buttons (Warm and Cool) can use both of them to simplify navigation and programming where a single Temperature icon is shown. In the navigation diagrams Temperature buttons are indicated by a single button icon. ![]() Some panels have separate WARM (Up) and COOL (Down) buttons, while others have a single Temperature button. Navigating the entire menu structure is done with 2 or 3 buttons on the control panel. User Interface and Programming Reference – Standard Menus System Model:īP-Series Systems are BP5XX, BP6XX, BP1XXX, BP2XXX. 26.2 TP600 Balboa Topside control operation Videoīalboa TP600 and TP400 Control Panels Manual.26.1 Hot Tub Suppliers Complete Guide To The Balboa TP600 Video.25.1 Basic Installation and Configuration Guidelines.24.7 A Pump Appears to have been Stuck ON when spa was last powered – M035.24.6 A Pump Appears to be Stuck ON – M034.24.5 GFCI Failure - System Could Not Test/Trip the GFCI – M036.24.4 Configuration Error – Spa will not Start Up.24.3 Memory Failure - Clock Error – M020 - Not Applicable on the BP1500.24.2 Memory Warning - Persistent Memory Reset – M021.24.1 Memory Failure - Checksum Error – M022. ![]() 22.3 Sensor Failure – Sensor A: M031, Sensor B: M032.21.2 Heater Flow is Reduced (LF) – M017.21.1 Heater Flow is Reduced (HFL) – M016.20.5 Safety Trip - Pump Suction Blockage – M033.12.2 Filter Cycle 2 - Optional Filtration.1 User Interface and Programming Reference – Standard Menus. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |